Furuno FAR-2827, FAR-2127-BB, FAR-2117-BB Attaching plastic cover for Gyro Converter board

4.INSTALLING OPTIONAL EQUIPMENT

5.Confirm gyrocompass specifications and set up the DIP switches and jumper wires on the GYRO CONVERTER board according to gyrocompass connected:

ξ Setting jumper wires and DIP switches by gyrocompass specifications: page 4-5

ξ Setting jumper wires and DIP switches by make and model of gyrocompass: page 4-7

ξ Location of jumper wires and DIP switches: page 4-8

6.Pass gyrocompass cable through the cable clamp and connect it to connector J602 as shown in the figure on page 4-3.

7.Attach the clamps on the plastic cover and then attach the cover to the GYRO CONVERTER board as shown in the figure below. Insert cables to the clamp ED-1, respectively.

Plastic cover	Screw
	M4x8 3 pcs
	Clamp CKS-10-L
Clamp EDS-1
Insert cables to these	Clamp CKS-13-L
clamp.

12

4
	1
	3
	1
	3
	1
	3
1	1
	5
	21
	1
	12

7

1

1

1

Attaching plastic cover for GYRO CONVERTER board

8. Close the processor unit.

4-4