Furuno FAR-2117, FAR-2827, FAR-2127-BB Input, Output, Data Specifications Contents Remarks

5. INPUT/OUTPUT DATA

Input and output data are shown in the table below.

Note: This radar accepts position data fixed by WGS-84 geodetic datum only. Set the datum to WGS-84 on the EPFS (GPS, etc.) connected to this radar. If other type of datum is input, the error message "DATUM" appears and the AIS feature is inoperative. Baud rate for the serial input is automatically set to 4800, 9600, 19200 or 38400 as appropriate.

Input

Data	Specifications		Contents	Remarks
Heading signal	synchro or step		GC-10 required	AD-10 and
				IEC 61162 are switched by
	AD-10 format		External AD-100
				menu setting.
	IEC 61162-2**
Speed signal	IEC 61162-1
Navaid data	IEC 61162-1		Position, course,	For IMO spec, IEC-61162-1
			speed, LORAN-C TD,	Edition 2 is required.
			waypoint, route, time,
			wind data, current
			data, depth,
			temperature, roll,
			pitch, ROT
External radar	Heading,		No STC control	Operate as remote display
signal	Bearing, Trigger,
	Video
Alarm ACK input	Contact closure			Input from alarm system
	IEC61162-1		ACK	Input from alarm system
Track Control unit	RS-422			Option
Output
Radar system data	RS-232C	RSD, OSD, TLL,		For PC plotter
TT data*	IEC 61162-1	TTD, TTM		For ECDIS
ALARM data	IEC 61162-1	ALR		For ALARM system
Remote display	HD, BP Trigger,			2 ports
signal	Video
External LCD	DVI	Same as main display		2 systems in total
monitor signal		unit
External CRT	R, G, B, H, V	Same as main display		Option
monitor signal		unit
Alarm signal	Contact closure	Output to alarm system		4 systems, Output contents
		by using photo-relay		are selected by menu.
	IEC 61162-1	ALR		Output to alarm system

*The output sentence, mode and baud rate can be set at the TT Preset menu. **Data cycle should be input with more than 40 Hz (HSC) or 20 Hz (normal speed).

5-1