2. WIRING
11.Set the transceiver module to the antenna unit, push it in until it stops, and then tighten fixing bolts (4 pcs.). Connect plugs P823, P803, P831, P921 and J911 (if installed). Fasten the shield wire to the wing nut on the transceiver module.
CAUTION
Push in transceiver unit until it stops.
Failure to do so may cause leakage of microwaves.
| Clamp for | |
03P9349 | coaxial cable | |
Connect coaxial cable here. | ||
| ||
| Transceiver module | |
Connector | Signal cable | |
plug |
|
|
|
|
|
|
|
|
|
|
| Connect shield wire to with wing |
Cable clamp for Bow mark |
|
|
|
|
|
|
|
| nut at the opposite side of the | |
antenna cable |
|
|
|
|
|
|
|
| transceiver module. | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Antenna unit, front view
12.Confirm that all screws are tightened and all wiring is properly made. Confirm that waterproofing gasket, bolts and tapping holes of antenna unit are coated with silicone grease. Close the antenna unit cover (torque: 2.5 N·m).
