Galaxy 65 User Guide

You can also set it to NONE, which tells the Galaxy 65 Subsystem not to present a LUN for this EMP under the Galaxy 65 Subsystem’s target ID.

You can set LUNs for EMPs that you plan to add by assigning a LUN to the EMP ID you want to use. The Galaxy 65 Subsystem assigns EMP IDs sequentially each time it starts.

Note EMP LUN settings have no effect on the CAPI interface, which always allows communication with all of the EMPs connected to the Galaxy 65 Subsystem.

You may want to change the EMP LUN if it conflicts with the LUN of another device.

To change the EMP LUN:

1From SAM, select Manage Galaxy 65 Subsystem > General Config > Enclosure Management.

The Enclosure Management page displays. The Set Galaxy 65 EMP LUNs panels display the current LUN for each EMP. Each EMP has an EMP number that the Galaxy 65 Subsystem assigns sequentially whenever it starts.

2Select the LUN you want for each EMP.

3Click Update EMP Configuration.

6.2.2 Changing the Additional EMP Setting

You can change four additional EMP settings:

EMP Polling Rate: This is the interval, in seconds, that the Galaxy 65 Subsystem polls the EMPs for status changes. If the polling rate is set to zero, the Galaxy 65 Subsystem does not communicate with the EMP. Only use this setting if you suspect you are having communication problems with the EMP. The default setting is five seconds.

To change the EMP setting:

1From SAM, select Manage Galaxy 65 Subsystem > General Config > Enclosure Management. The Enclosure Management page displays.

2In the Enclosure Management Processor General Settings panel, select EMP Polling Rate.

3Click Update EMP Configuration

58

Page 78
Image 78
Galaxy Metal Gear 65 manual Changing the Additional EMP Setting, Click Update EMP Configuration