4Close the case by following the instructions on page 31, then reconnect the power cord.
5Place the bootable diskette containing the BIOS files into drive A:, then turn on the server.
At the start of the BIOS recovery process, the server beeps once. The recovery process may take a few minutes.
6When the process is completed, you will be prompted to remove the diskette from drive A: and turn off the server.
7Disconnect the power cord and remove the back top panel again. (See “Removing the back top panel” on page 28 and “Preventing static electricity discharge” on page 25.)
8Place the jumper back on pins
9Close the case, reconnect the cords, then turn on the server.
10Enter the BIOS Setup utility by pressing F2 when the Gateway Logo screen appears.
11Once in BIOS Setup utility, go to the appropriate tabs and select any BIOS fields you want to change, then reenter the values you wrote down at the beginning of this process.
12Save your changes, then exit the BIOS Setup utility.
Troubleshooting: If the BIOS recovery was unsuccessful, go back to the Gateway Web site and start the process over. If you continue to have problems, contact Client Care or your system administrator.
Setting the system board jumpers | 117 |