8Close the card retention mechanism at the end of the card, if the card is full length.

9Connect any cables to the card (see card documentation for proper cable orientation).

10Close the case. (See “Closing the case” on page 31.)

11Reconnect the peripherals and the power cord, then turn on the server.

You may need to reconfigure the server after replacing a hot-swap expansion card. You may also need to install upgrade software that came with the card. Check the card documentation for additional information.

Replacing an expansion card

The server supports as many as two 32-bit, 33 MHz PCI expansion cards. These cards are not hot-swap cards and you must turn off the server before replacing one.

To replace an expansion card:

1Set any jumpers and switches on the replacement card, if required in the card instructions.

2Turn off the server, then disconnect the power cord and all external peripheral devices.

3Remove the back top panel according to the instructions in “Removing the back top panel” on page 28. (See “Preventing static electricity discharge” on page 25.)

76Replacing and Adding Internal Devices