Adding an expansion card

The server supports as many as two 32-bit, 33 MHz PCI expansion cards. These cards are not hot-swap cards and you must turn off the server before installing one.

To install an expansion card:

1Set any jumpers and switches on the replacement card, if required in the card instructions.

2Turn off the server, then disconnect the power cord and all external peripheral devices.

3Remove the back top panel according to the instructions in “Removing the back top panel” on page 28. (See “Preventing static electricity discharge” on page 25.)

4Remove the EMI foam cover over the processors.

80Replacing and Adding Internal Devices