Installing a 5.25-inch device

The chassis supports a single half-height 5.25-inch device. The 5.25-inch drive bay is in the center of the front panel (see “System board” on page 13.)

To install a 5.25-inch device:

1Turn off the server and disconnect the power cord and all other external peripheral devices.

2Remove the bezel. (See “Removing the bezel” on page 27.)

3Remove the front top panel. (See “Removing the front top panel” on page 29 and “Preventing static electricity discharge” on page 25.)

4Pull out the metal electro-magnetic interference (EMI) shield from the front of the 5.25-inch drive bay and save it in case you need to remove the 5.25-inch device you are installing.

5Install the drive rails on the 5.25-inch device. (See the documentation that came with the device for any jumper settings and cable orientation information.)

Drives 49