GoVideo GV8050 manual Correcting Mistakes

▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲

Note:

If there is any information in the Scene Edit List, you won’t be able to reset the 8mm Tape Counter or eject the 8mm tape using the remote control. This is a safeguard to prevent you from accidentally losing your scene information. Use the front panel 8mm STOP/EJECT key if you need to eject the tape. This clears all scene information. You can also

press MEMORY while in the

Scene Edit List to clear all information.

ASSEMBLING: 1 2 5

6.Play the 8mm tape until you get to the place where you want your scene to end, and press END .

➤The Scene Edit List will proceed to Scene 2. ‘2’ and ‘BEGIN’ will flash.

7.Repeat steps 4-6 for up to eight scenes.

8.Press STOP to stop the 8mm deck.

9.Press COPYTAPE .

➤Sit back and watch the 8mm/VHS Dual-Deck VCR assemble and copy your scenes! You’ll see a message telling you which scene number is currently being assembled and copied (that number will flash). Press DISPLAY if you want to see the deck functions as the scenes are copied.

The Scene numbers 1-8 indicate the order in which the scenes will be copied onto your VHS tape. This does not mean that you have to program Scenes 1 through 8 sequen- tially. For example, if you want the material at the begin- ning of your 8mm tape to appear at the end of your VHS copy, enter the Scene Edit List, and press SCENE repeatedly until Scene 8 is flashing. Mark the beginning and end of Scene 8. Then, program scenes 1 through 7 in any order.

Correcting Mistakes

Before you press COPYTAPE , you can easily delete any scene from the Scene Edit List, and reprogram that scene. To delete a scene, press SCENE until the scene number is flash- ing. Press RESET to clear the BEGIN and END data. If you want to reprogram the scene, repeat steps 4-6 above.

AUTOMATIC ASSEMBLY EDITING 17