Hitachi L100 Output Terminal Configuration

3–36

“C” Group: Intelligent Terminal Functions

Output Terminal Configuration

The inverter provides configuration for logic (discrete) and analog outputs, shown in the table below.

		“C” Function		Run		Defaults
Func.	Name /		Description	Mode	–FE	–FU	–FR	Units
				Edit
Code	SRW Display				(CE)	(UL)	(Jpn)
C_21	Terminal [11] function		Select function for terminal	✘	01	01	01	—
			[11], 6 options (see next		[FA1]	[FA1]	[FA1]
	OUT-TM 1	FA1
			section)
C_22	Terminal [12] function		Select function f or terminal	✘	00	00	00	—
			[12], 6 options (see next		[RUN]	[RUN]	[RUN]
	OUT-TM 2	RUN
			section)
C_23	[FM] signal selection		Select function for terminal	✘	00	00	00	—
			[FM], 3 options (see next		[A–F]	[A–F]	[A–F]
	MONITOR	A-F
			section)

Configuring Drive Parameters

The output logic convention is programmable for terminals [11] and [12]. The open- collector output terminals [11] and [12] default to normally open (active low), but you can select normally closed (active high) for these terminals in order to invert the sense of the logic. You can invert the logical sense of the alarm relay output as well.

		“C” Function			Run		Defaults
Func.	Name /			Description	Mode	–FE	–FU	–FR	Units
					Edit
Code	SRW Display					(CE)	(UL)	(Jpn)
C_31	Terminal [11] active		Select logic convention, two		✘	—	00	—	—
	state (–FU)		option codes:
			00	...normally open [NO]
	OUT-TM O/C-1	NO
			01	...normally closed [NC]
	Reserved (–FE / –FR)		(reserved) DO NOT EDIT		✘	00	—	00	—
	(not displayed)
C_32	Terminal [12] active		Select logic convention, two		✘	—	00	—	—
	state (–FU)		option codes:
			00	...normally open [NO]
	OUT-TM O/C-2	NO
			01	...normally closed [NC]
	Terminal [11] active		(reserved) DO NOT EDIT		✘	00	—	00	—
	state (–FE / –FR)
	OUT-TM O/C-1	NO
C_33	Alarm relay active state		Select logic convention, two		✘	01	01	01	—
			option codes:
	OUT-TM O/C-RY NO
			00	...normally open [NO]
			01	...normally closed [NC]