●The system will operate in single channel mode if the SODIMM sockets are populated in one channel only.
●The system will operate in flex mode if the memory capacity of the SODIMM in Channel A is not equal to the memory capacity of the SODIMM in Channel B. In flex mode, the channel populated with the least amount of memory describes the total amount of memory assigned to dual channel and the remainder is assigned to single channel. If one channel will have more memory than the other, the larger amount should be assigned to channel A.
●The system will operate in a
●In any mode, the maximum operational speed is determined by the slowest SODIMM in the system.
There are two memory sockets on the system board located behind the memory access panel. To remove or install memory modules:
To remove a memory module:
1.Prepare the computer for disassembly (see Preparing to disassemble the computer on page 18).
2.Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel, or other soft cloth to protect the screen surface from scratches or other damage.
3.Remove the rear cover (see Rear cover on page 19).
4.Remove the system board cover (see System board cover on page 38).
5.To remove a memory module, press outward on the two latches on each side of the SODIMM (1), then pull the SODIMM out of the socket (2).
The computer automatically recognizes the additional memory when you turn on the computer.
Memory 41
