![](/images/new-backgrounds/1308232/308232181x1.webp)
Power LED flashes Red five times, once every second, followed by a two second pause, and the computer beeps five times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause | Solution |
|
|
NOTE: DIMM1 or XMM1 must always be installed. On all computers except the USDT, DIMM1 must be installed before DIMM2, and DIMM3 must be installed before DIMM4
3. Replace
4. Replace the system board.
Power LED flashes Red six times, once every second, followed by a two second pause, and the computer beeps six times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause | Solution | |
|
| |
Graphics card (some models) is not seated properly or is bad, or | For systems with a graphics card: | |
system board is bad. | 1. | Reseat the graphics card. Power on the system. |
| ||
| 2. | Replace the graphics card. |
| 3. | Replace the system board. |
For systems with integrated graphics, replace the system board.
Power LED flashes Red ten times, once every second, followed by a two second pause, and the computer beeps ten times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause | Solution | |
|
|
|
Bad option card. | 1. | Check each option card by removing the cards one at time (if |
|
| multiple cards), then power on the system to see if fault |
|
| goes away. |
| 2. | Once bad card is identified, remove and replace bad option |
|
| card. |
| 3. | Replace the system board. |
|
|
|
Solving Network Problems
Some common causes and solutions for network problems are listed in the following table. These guidelines do not discuss the process of debugging the network cabling.
Table 7-11 Solving Network Problems
Cause | Solution |
|
|
S5 Maximum Power Saving feature is enabled. | Disable the S5 Maximum Power Saving option in Computer Setup. |
| Select Power > Hardware Power Management > S5 Maximum |
| Power Savings. |
|
|