HP 330, 350 manual Description Comments

COMMUNICATION ERROR CODES (Continued)

TRANSMIT ERRORS (500 level codes) – Code numbers not listed are not used

CODE	DESCRIPTION	COMMENTS
501	Line busy	Busy tone detected during initial handshake. “BUSY” dis
		played on journal.
502	DCN received	A DCN was received in a command frame that was receiv
		in response to CNG. The remote side ended the session by
		sending DCN (disconnect) very early in the session setu
		Between 2 HP OfficeJet Series 300s, you can cause this con-
		dition by pressing STOP on the receiving unit immediate
		upon seeing the “Answering...” display.
503	Line disconnect	Receiver sent DCN and dropped the line after waiting 3 s
		onds for a received frame or the line signal was gone
		than 0.2 seconds.
504	Irrelevant response	Command following CNG was not valid.
505	Time-out	T1 timer elapsed and no response received. “No answer”
		played on journal report.

511Incompatible remote receiverReceiver is non-compatible for customizable function

512Incompatible remote receiverReceiver is non-compatible or polling was requested nied.

513Polling password incorrectYou were polled and there was no document to send.

514No documents to be polledThe polling unit does not look at the DIS which says w not have a document to poll and requests us to send way.

515	Time-out	Timer has elapsed.
521	DCN received	DCN was received in a response frame following the tra
		phase. The remote side ended the session by sending DCN
		(disconnect) during the session setup. Between 2 HP
		OfficeJet Series 300s, you can cause this condition by pre
		ing STOP on the receiving unit immediately upon seeing
		“Connecting...” display.
522	Line disconnect	Receiver sent DCN and dropped the line after waiting 3 s
		onds for a received frame or the line signal was gone
		than 0.2 seconds.

523No response on all retries No response was received on all 3 attempts to establis nection with DCS.We lost connection with the receiver, because the line dropped or because the receiver hun

524	Identification received	Failure to sync with the remote unit. The line may be
		tive which keeps the remote unit from seeing the DCS c
		mand.
525	Fallback impossible	Fallback in modem speed is needed but impossible (for
		ple: receiver supports V.29 but V.27 is needed). All attempts
		to train with the remote unit have failed. The HP Office
		Series 300 attempts to train at 9600, 7200, 4800 and 2400
		baud.

(Continued on next page)

Problem Resolution5-37