HP 6000 Router manual port 100BASE-F SM FIC interface attributes, SC optical fiber connector

1-port 100 FX MM FIC (3C13860) and 1-port 100 FX SM FIC (3C13862) 61

Table 2 The 1-port 100BASE-F SM FIC interface attributes

Attribute	Description
Connector	SC	Connector number
1	Optical fiber mode	Single-mode
Multimode	Max. transmission	15km
	distance
2km	Central wavelength	1310nm (1261~1360nm)
1315nm	Transmitting optical	Min.
(1270-1360nm)	power
-15dBm	20dBm	Max.
-8dBm	-14dBm	Receiving sensitivity
Min.	-31dBm	-31dBm
Max.	-8dBm	-14dBm
Operating mode	Full duplex	100Mbps
Supported frame	Ethernet_II	Ethernet_SNAP
format

Panel and Interface LEDs The following illustrates the LEDs of the The 1-port 100 FX MM FIC

Figure 3 1-port 100 FX MM FIC panel 1SFX panel

Table 3

Table 4 LED description of the 100BASE-F SM, 100BASE-MM

LINK	OFF means Rx link is disconnected, and ON means Rx link has been connected.
ACTIVE	OFF means no data is being transceived on the interface and blinking means
	data is being transcieved.

Interface Optical Fiber 100 FX MM should be connected to multi-mode optical fiber, and 100 FX SM to single-mode optical fiber. The optical interfaces of both cards are SC optical receptacles, so the optical fibers with SC connector should be selected.

Figure 4 SC optical fiber connector