HP 6000 Router manual Boot Sub-menu, Modifying serial port parameters, Starting Boot main system

38CHAPTER 4: SOFTWARE MAINTENANCE

Boot Sub-menu

The following information will be displayed on the terminal screen when the system enters Boot sub-system successfully.

============<SMALL-BOOTROM MENU(Ver 1.07)>=============

<1> Update LargeBootrom <2> Boot main system

===========================================================

Enter your choice(1-2):

Modifying serial port parameters

1Enter <1> in Boot sub-system and the system will begin to change baudrate of the serial port on RPU card, as will reduce the time to load necessary files. The system prompts the following information:

========================<BAUDRATE SET>========================= Note: Change The HyperTerminal's Baudrate Accordingly.

-----------------------	<BaudrateAvaliable>------------------
<1> 9600(Default)
<2> 19200
<3> 38400
<4> 57600
<5> 115200

================================================================

Enter Your Choice(1-5):

The information indicates you to choose the desired baudrate. By default, the baudrate is 9600 bps.

2Select a target item and press <Enter>. When you select <5>, the system prompts:

Enter your choice(1-5): 5

Change The BaudRate On PC Side First!

3Select [File/Attributes] at HyperTerminal in the configuration PC and press

<Configuration> in the dialog box. In the dialog box, change the baudrate to a desired value and press <OK>.

4Disconnect the system and resume dialup, to make the new parameter take effect.

The Current BaudRate is 115200

You should reset the HyperTerminal baudrate to the default value 9600bps when upgrading, by changing rate downloading files, to prevent output information from being prompted on the terminal screen after system startup or restart.

Upgrading Boot main system (LargeBootrom) through serial port

Enter <2> in Boot sub-system and choose to upgrade Boot main system via

Xmodem.

Starting Boot main system

Enter <3> in Boot sub-system and the system will then copy the files in Boot main system into SDRAM. It will also decompress and start the files. Then the system will start Boot main menu.