HP 6120 Transitioning to Multiple Configuration Files, write mem, oldConfig, write memory

Switch Memory and Configuration

Multiple Configuration Files

2.Use the CLI to make configuration changes in the running-config file, and then execute write mem.

The result is that the startup-config file used to reboot the switch is modified by the actions in step 2.

Boot Command

Primary Boot Path

Active Startup-Config File:

backupConfig

Idle Startup-Config File:

workingConfig

Generated Running-Config File

Use CLI To Change Running-Config

Execute write mem To Save Changes to

Source Startup-Config File

Figure 6-18. Example of Reboot Process and Making Changes to the Startup- Config File

Creating an Alternate Startup-Config File. There are two methods for creating a new configuration file:

■Copy an existing startup-config file to a new filename, then reboot the switch, make the desired changes to the running-config file, then execute write memory. (Refer to figure 6-6-18,above.)

■Erase the active startup-config file. This generates a new, default startup- config file that always results when the switch automatically reboots after deletion of the currently active startup-config file. (Refer to “Erasing a Startup-Config File” on page 6-35.)

Transitioning to Multiple Configuration Files

At the first reboot with a software release supporting multiple configuration, the switch:

■Assigns the filename oldConfig to the existing startup-config file (which is stored in memory slot 1).

6-27