
If the pinch wheels do not apply the same pressure on both edges, then do the following:
a.Reposition the media so that the pressure is equal at both edges of the media:
●Lower the media lever;
●Loosen the stop screws on the media holders;
●Adjust the position of the roll left or right along the support bar;
●Tighten the stop screws on the media holders;
●Raise the media lever.
NOTE Take care that the media is flat and does not catch on the pinchwheels while changing the position.
How do I load/unload media
ENWW | Install a media roll in the printer | 27 |