●Example of when the pressure release lifter does not need to be pulled out to release unequal pressure from the Pinchwheel at the edge of the media;
14.Feed the media until a beep sounds from the media feeder (about 200 mm).
NOTE It is a good practice to feed the media through the media path until it almost touches the floor because when you rewind the excess media again this will ensure an even tension across width of the media and avoid skew.
How do I load/unload media
NOTE If you have problems loading media, feed the media into the printer by holding both edges of the media.
Take care that the media does not curl inside the front cover and that the media edge guards are not obstructing the media path.
ENWW | Install a media roll in the printer | 29 |