Maintain the

HP All -in

-One

Chapter 12

To clean the area around the ink nozzles

1.Make sure the product is turned on.

CAUTION: If the product is turned off when you open the print cartridge door to access the print cartridges, it will not release the cartridges for changing. You might damage the product if the print cartridges are not docked safely when you try to remove them.

2.Open the print cartridge door.

The print carriage moves to the far right side of the product.

3.Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the product.

4.Lightly press down on the print cartridge to release it, and then pull it towards you out of the slot.

NOTE: Do not remove both print cartridges at the same time. Remove and clean each print cartridge one at a time. Do not leave a print cartridge outside the product for more than 30 minutes.

5.Place the print cartridge on a piece of paper with the ink nozzles facing up.

6.Lightly moisten a clean foam rubber swab with distilled water.

112 Maintain the HP All-in-One

Page 115
Image 115
HP C5500 manual To clean the area around the ink nozzles