Chapter 15

To remove the control panel faceplate

1.Press the On button to turn off the HP All-in-One.

2.Unplug the power cord, and then disconnect it from the HP All-in-One. Do not return the power cord with the HP All-in-One.

3.Remove the control panel faceplate as follows:

a. Place your hands on each side of the control panel faceplate.

b. Place the fingertips of your left hand in the small gap under the display, and then pry the faceplate down and to the right.

4.Retain the control panel faceplate. Do not return the control panel faceplate with the HP All-in- One.

CAUTION: The replacement HP All-in-One might not come with a control panel faceplate. Store your control panel faceplate in a safe place, and when the replacement HP All-in-One arrives, reattach your control panel faceplate. You must attach your control panel faceplate to use the control panel functions on the replacement HP All-in-One.

NOTE: See the Start Here guide that came with the HP All-in-One for instructions on how to attach your control panel faceplate. The replacement HP All-in-One might come with instructions for setting up your device.

Pack the HP All-in-One

Complete the following steps once you have removed the print cartridges, removed the control panel faceplate, turned off the HP All-in-One, and unplugged it.

To pack the HP All-in-One

1.If available, pack the HP All-in-One for shipment by using the original packing materials or the packaging materials that came with your exchange device.

HP warranty and support

274 HP warranty and support

Page 277
Image 277
HP C5500 manual Pack the HP All-in-One