The printout has a horizontal band of distortion near the bottom of a borderless print
Try the following solutions if your borderless print has a blurry band or line on the bottom of it.
NOTE: For this issue, there is not a problem with your ink supplies. Therefore, replacing the print cartridges is not necessary.
•Solution 1: Check the paper type
•Solution 2: Check the print quality setting
•Solution 3: Rotate the image
Solution 1: Check the paper type
Solution: HP recommends that you use HP Premium Papers or any other paper type that is appropriate for the product.
Always make sure the paper you are printing on is flat. For best results when printing images, use HP Premium Plus Photo Paper.
For more information, see:
Store and handle photo paper
Cause: The wrong kind of paper was loaded in the input tray.
If this did not solve the issue, try the next solution.
Solution 2: Check the print quality setting
Solution: Check the quality setting. Use a higher quality setting to increase the amount of ink used for printing.
For more information, see:
•Change the print speed or quality
•Maximum dpi
Cause: The print quality setting was set to low.
If this did not solve the issue, try the next solution.
Solution 3: Rotate the image
Solution: If the problem persists, use the software you installed with the product or another software application to rotate your image 180 degrees so that the light blue, gray, or brown hues in your image do not print at the bottom of the page.
Cause: The photo image had light blue, gray, or brown hues that print near the bottom of the page.
Troubleshooting
Print quality is poor | 91 |
