![](/images/new-backgrounds/1270278/270278135x1.webp)
Comments ∙ Enabling the Trigger Source: The TRIGger:SOURce command only selects the trigger source. The INITiate[:IMMediate] command enables the trigger source.
∙Using the TRIG Command: You can use TRIGger[:IMMediate] to advance the scan when TRIGger:SOURce BUS or TRIGger:SOURce HOLD is selected.
∙Using External Trigger Inputs: With TRIGger:SOURce EXTernal selected, only one switchbox at a time can use the external trigger input at the HP E1300/E1301 Mainframe’s "Event In" port. The trigger input is assigned to the first switchbox requesting the external trigger source (with a TRIGger:SOURce EXTernal command).
∙Assigning External Trigger: A switchbox assigned with
TRIG:SOUR EXT remains assigned to that source until it receives a command to change the source to BUS, HOLD, or IMMediate. When the source is changed, the external trigger source is available to the next switchbox which requests it (with a TRIGger:SOURce EXTernal command). If a switchbox requests an external trigger input already assigned to another switchbox, an error is generated.
∙Using Bus Triggers: To trigger the switchbox with TRIGger:SOURce BUS selected, use the IEEE 488.2 common command *TRG or the
∙"Trig Out" Port Shared by Switchboxes: See the OUTPut command.
∙Related Commands: [ROUTe:]SCAN, TRIGger, ABORt
∙*RST Condition: TRIGger:SOURce IMMediate
Example Scanning Using External Triggers
This example uses external triggering (TRIG:SOUR EXT) to scan channels 00 through 02 of a
TRIG:SOUR EXT | Sets trigger source to external. |
SCAN (@100:102) | Scan channels 00 through 02. |
INIT | Begin scan, close channel 00. |
trigger externally | Advance scan to next channel. |
68 HP E1368A/69A/70A Command Reference | Chapter 4 |