N
Numeric Command Parameters, 49
O
*OPC, 70 *OPC?, 70
OPEN, ([ROUTe:]OPEN), 14, 29, 59, 71
OPEN?, ([ROUTe:]OPEN?), 46, 60, 71 Opening
channels, 31, 59
Operation Status Register, 41, 62 - 63 OPERation:ENABle, (STATus:OPERation:ENABle), 41, 63, 71
OPERation:ENABle?, (STATus:OPERation:ENABle?), 46, 63, 71 OPERation[:EVENt]?, (STATus:OPERation[:EVENt]?), 41, 46, 64, 71 Optional Command Parameters, 49
Optional Commands, 16, 48
OUTPut Subsystem, 57, 71 OUTPut[:STATe], 29 - 30, 57, 71 OUTPut[:STATe]?, 46, 57, 71
P
Parameters, 49
connecting to different, 14, 33 Event In, 68
ext trig in, 40 numbers, 34 trig out, 39, 57
Power Supply, 13, 24 Programming the Switches, 14
Q
Query commands, 46 error queue, 66 monitor mode state, 54 number of scanning cycles, 52 open/closed channels, 59 - 60 scanning mode state, 61 scanning states, 56
the microwave switch, 46 trig out port, 57
trigger sources, 69
R
*RCL, 43, 70
Reader comment sheet, 9 Reading the Registers, 76 Recalling Switch States, 43 Registers, 75 - 78
addressing, 76
channel enable, 75 - 77 definitions, 75 device type, 75 manufacturer ID, 75 - 76 operation status, 41, 62 - 63 reading, 76
standard event status, 43 standard operation status, 62 status, 41, 63 status/control, 75, 77 writing to, 77
Removing Jumpers, 24 Reset
conditions, 30 default values, 30 switchbox, 16
Ribbon Cable
connecting to external device, 35 pin numbers, 33
ROUTe: Subsystem, 58 - 61, 71 ROUTe:CLOSe, 14, 29, 58, 71 ROUTe:CLOSe?, 29, 46, 59, 71 ROUTe:OPEN, 14, 29, 59, 71 ROUTe:OPEN?, 46, 60, 71 ROUTe:SCAN, 29, 60, 71 ROUTe:SCAN:MODE, 30, 61, 71 ROUTe:SCAN:MODE?, 46, 61, 71 ROUTe:SCAN:PORT, 30 Routing Signals, 36 - 38
*RST, 29 - 30, 70 - 71
