Make sure you have the following materials available:

Dry foam rubber swabs, lint-free cloth, or any soft material that will not come apart or leave fibers.

TIP: Coffee filters are lint-free and work well for cleaning ink cartridges.

Distilled, filtered, or bottled water (tap water might contain contaminants that can damage the ink cartridges).

CAUTION: Do not touch the copper-colored contacts or ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.

To clean the area around the ink nozzles

1.Turn on the device and open the ink cartridge door.

The print carriage moves to the far right side of the device.

2.Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the device.

NOTE: Depending how long the HP All-in-One is unplugged, the date and time might be erased. You might need to reset the date and time later, when you plug the power cord back in.

3.Lightly press down on the ink cartridge to release it, and then pull it toward you out of the slot.

NOTE: Do not remove both ink cartridges at the same time. Remove and clean each ink cartridge one at a time. Do not leave an ink cartridge outside the device for more than 30 minutes.

4.Place the ink cartridge on a piece of paper with the ink nozzles facing up.

5.Lightly moisten a clean foam rubber swab with distilled water.

Work with ink cartridges

107

Page 111
Image 111
HP J4660 manual To clean the area around the ink nozzles