Chapter 7

Set up the device with a computer dial-up modem

If you are using the same phone line for sending faxes and for a computer dial-up modem, follow these directions for setting up the device.

Figure 7-6 Back view of the device

1

Telephone wall jack

2

Use the phone cord supplied in the box with the device to connect to

 

the "1-LINE" port

3

Computer with modem

 

 

To set up the device with a computer dial-up modem

1.Remove the white plug from the port labeled 2-EXT on the back of the device.

2.Find the phone cord that connects from the back of your computer (your computer dial-up modem) to a telephone wall jack. Disconnect the cord from the telephone wall jack and plug it into the port labeled 2-EXT on the back of the device.

3.Using the phone cord supplied in the box with the device, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the device.

NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the device, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office.

4.If your modem software is set to receive faxes to your computer automatically, turn off that setting.

NOTE: If you do not turn off the automatic fax reception setting in your modem software, the device will not be able to receive faxes.

5.Turn on the Auto Answer setting.

6.(Optional) Change the Rings to Answer setting to the lowest setting (two rings).

7.Run a fax test.

When the phone rings, the device automatically answers after the number of rings you set in the Rings to Answer setting. The device begins emitting fax reception tones to the sending fax machine and receives the fax.

78 Configure and manage

Page 82
Image 82
HP J4660 manual Set up the device with a computer dial-up modem, To set up the device with a computer dial-up modem