Chapter 8

Solve scan problems

If the following topics do not help, see Support and warranty for information about HP support.

NOTE: If you are starting the scan from a computer, see the software Help for troubleshooting information.

Scanner did nothing

Scan takes too long

Part of the document did not scan or text is missing

Text cannot be edited

Error messages appear

Scanned image quality is poor

Scan defects are apparent

Scanner did nothing

Check the original

Make sure that the original is placed on the scanner glass correctly. For more information, see Load an original on the scanner glass.

Check the device

The device might be coming out of PowerSave mode after a period of inactivity, which delays processing a short while. Wait until the device reaches the READY state.

Check the software

Make sure the software is properly installed.

Scan takes too long

Check the settings

ƕIf you set the resolution too high, the scan job takes longer and results in larger files. To obtain good results when scanning or copying, do not use a resolution that is higher than needed. You can lower the resolution to scan more quickly.

ƕIf you acquire an image through TWAIN, you can change the settings so that the original scans in black and white. See the onscreen Help for the TWAIN program for information.

Check the status of the device

If you sent a print or copy job before you tried to scan, the scan starts if the scanner is not busy. However, the printing and scanning processes share memory, which means that the scan might be slower.

126 Maintain and troubleshoot

Page 130
Image 130
HP J4660 manual Solve scan problems, Scanner did nothing, Scan takes too long, Check the software