Network Setup menu
In the following table, items that have an asterisk (*) indicate the factory default setting.
Menu item | Description |
Wireless Menu
NOTE: You can also access this menu by touching the Wireless 
button on the control panel.
Wireless Direct Settings Wireless Direct On/Off | Enables or disables the Direct | ||
|
| feature. | |
|
|
| |
| Wireless Direct Name | Set the product's Direct Wifi name, so you can access it | |
|
| from other wireless devices that support the | |
|
| protocol. | |
|
|
| |
| Wireless Direct Mode | Set the product's Direct Wifi mode. | |
|
| ● | Select the Print Only option (the default setting) to |
|
|
| allow wireless access to only the product print |
|
|
| functions from a mobile device. |
|
| ● | Select the Open Network option to allow wireless |
|
|
| access to all product functions and settings from a |
|
|
| mobile device. |
|
|
| |
Wireless Setup Wizard | Guides you through the steps to set up the product on a | ||
|
| wireless network | |
|
| ||
If your wireless router supports this feature, use this | |||
|
| method to set up the product on a wireless network. This | |
|
| is the simplest method. | |
| Run Network Test | Tests the wireless network and prints a report with the |
|
| results. |
|
|
|
| Turn Wireless On/Off | Enables or disables the wireless network feature. |
|
|
|
TCP/IP Config | Automatic* | Automatic: The product automatically configures all the |
| Manual | TCP/IP settings via DHCP, BootP or AutoIP. |
|
| |
|
| Manual: You can manually configure the IP address, |
|
| subnet mask, and default gateway. The control panel |
|
| prompts you to specify values for each address section. |
|
| As each address is completed, the product prompts for |
|
| address confirmation before moving to the next one. After |
|
| all three addresses are set, the network reinitializes. |
|
|
|
Auto Crossover | On* | Enables or disables the use of a standard 10/100 network |
| Off | cable when the product is directly connected to a |
| computer. | |
|
|
|
Network Services | IPv4 | Enable or disable the IPv4 and IPv6 protocols. By default, |
| IPv6 | each protocol is enabled. |
|
| |
|
|
|
Link Speed | Automatic* | Sets the link speed manually if needed. |
| 10T Full | After setting the link speed, the product automatically |
| 10T Half | restarts. |
|
| |
| 100TX Full |
|
| 100TX Half |
|
|
|
|
28 | Chapter 2 Control panel menus | ENWW |