Set or change the product password

Use the HP Embedded Web Server to set a password or change an existing password for a product on a network.

1.Type the product IP address into the address line of a Web browser. Click the Networking tab, and click the Security link.

NOTE: If a password has previously been set, you are prompted to type the password. Type the password, and then click the Apply button.

2.Type the new password in the New Password box and in the Verify password box.

3.At the bottom of the window, click the Apply button to save the password.

Manually configure IPv4 TCP/IP parameters from the control panel

Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.

1.Touch the Setup button.

2.Scroll to and touch the Network Setup menu.

3.Touch the TCP/IP Config menu, and then touch the Manual button.

4.Use the numeric keypad to enter the IP address, and touch the OK button. Touch the Yes button to confirm.

5.Use the numeric keypad to enter the subnet mask, and touch the OK button. Touch the Yes button to confirm.

6.Use the numeric keypad to enter the default gateway, and touch the OK button. Touch the Yes button to confirm.

ENWW

Connect to a network with Windows

69