Set up fax
Install and connect the hardware
Connect fax to a telephone line
▲Connect the telephone cable provided with the product to the fax “line in” port 
on the product and to the telephone jack on the wall.
The product is an analog faxing device. HP recommends using the product on a dedicated analog telephone line. If you are using a digital environment, such as DSL, PBX, ISDN, or VoIP, make sure to use the correct filters and configure the digital settings correctly. For more information, contact your digital service provider.
NOTE: Some countries/regions might require an adapter to the phone cord that came with the product.
Connect additional devices
The product includes two fax ports:
●The fax “line in” port 
, which connects the product to the wall telephone jack.
●The fax “telephone line out” port 
, which connects additional devices to the product.
Telephones used in conjunction with the product can be employed in two ways:
●An extension phone is a phone plugged into the same phone line at another location.
●A downstream phone is one that is plugged into the product or a device that is plugged into the product.
Connect additional devices in the order that is described in the following steps. The output port for each device is connected to the input port of the next, forming a "chain". If you do not want to connect a specific device, skip the step that explains it and continue to the next device.
NOTE: Do not connect more than three devices to the telephone line.
NOTE: Voicemail is not supported with this product.
1.Unplug the power cords for all of the devices that you want to connect.
2.If the product is not yet connected to a telephone line, see the product installation guide before proceeding. The product should already be connected to a telephone jack.
170 Chapter 12 Fax | ENWW |