HP UX 11i v2 Networking Software Interpreting FTAM Errors, Table, Reason, FTAM Call, FTAM Call Errors, Corrective Action, Interpreting FTAM Errors

Interoperability Testing

Interpreting FTAM Errors

Interpreting FTAM Errors

Table 1-1 may help you to find what caused your FTAM test to fail.

1.Check the field labeled “Diagnostic”.

If this field is present, look for a text string labeled “further details” for the cause.

2.Look at the line after “FAILED”. The operation that failed is listed.

Table 1-1		FTAM Call Errors
		FTAM Call	Reason	Corrective Action
	ft_aeactivation()		FTAM not correctly	Run swverify on the FTAM
			installed.	fileset to verify that all
				components are installed.
			OTS stack not up.	Run the Status operation
				under Session or Transport to
				verify.
	ft_connect()		Incorrect address	Recheck the value of the
			specified.	Presentation address specified
				and the value configured for
				the remote.
			Incorrect User ID.	Check user name and
				password, usually corresponds
				to the remote.
			Remote stack not up.	Recheck stack.
			Responder not running.	Repeat the verification
				described in the pre-test
				section.
			Lower Layer Problem.	Go back to the step you were
				on and continue.
	ft_select()		Incorrect source file	Check the source file name
			name.	and correct.

16 Chapter 1