Interoperability Testing

FTAM Interoperability Testing

FTAM File Transfer Test

After a successful FTAM connect test. Follow the steps below to do an FTAM file transfer.

1.From the FTAM menu, create a new result file.

2.Select “Low Level Transfer.”

3.The initiator ID parameters are displayed.

a.Leave first ID set to local login.

b.Set first password to your local password.

c.Leave second set unchanged.

d.Press Done.

4.Leave source Presentation address unchanged. Press Done.

5.Leave destination address unchanged. Press Done.

6.If your system has a “message of the day” configured, leave the source and destination file names unchanged. If your system does not have a “message of the day” configured, overwrite the source file name with a valid name.

7.Check “TEST STATUS” near the end of the report.

If the status is “PASSED,” FTAM verification is complete.

If the status is “FAILED,” see “Interpreting FTAM Errors” on page 16, make your corrections, then re-run this test.

Chapter 1

15