Trap Definitions

Trap

File Name

Description

Switched to Alternate Host (7)

(trapSwitchedToAlternate)

Issued when switching to alternate IP

 

 

address due to loss of keep alive or loss of

 

 

TCP session when in permanent TCP

 

 

mode

 

 

 

Invalid Terminal Message (8)

(trapInvalidTerminalMessage)

Issued when an improperly formatted

 

 

message is received from a terminal

 

 

 

Terminal Poll Lost (9)

(trapTerminalPollLost)

Issued when a transition from receiving

 

 

responses to SDLC poll to no response is

 

 

detected

 

 

 

Terminal Poll Restored (10)

(trapTerminalPollRestored)

Issued when a transition from no poll

 

 

response to receiving a poll response is

 

 

detected

Admin Logged In (11)

(trapAdminLoggedIn)

Issued whenever anyone logs in to the

 

 

IN-tact1101 using the “admin” User ID

 

 

and password

 

 

 

Admin Logged Out (12)

(trapAdminLoggedOut)

Issued whenever “admin” logs out of the

 

 

IN-tact1101

Admin Password Changed (13)

(trapAdminPasswordChanged)

Issued whenever the password for the

 

 

User ID “admin” is changed

 

 

 

Session Timed Out (14)

(trapSessionTimedOut)

Issued when the five-minute timer expires

 

 

during a session. The session is closed

 

 

and the user is logged out

Maximum Failed Login Attempts

(trapMaxFiledLoginAttempts)

Issued whenever the three consecutive

(15)

 

failed attempts were made to log in to the

 

 

IN-tact1101

 

 

 

System Error (99)

(trapSystemError)

Issued when the device detects an

 

 

unexpected condition. A four-digit code

 

 

within the trap identifies the unexpected

 

 

condition. Refer to the Error Code table.

 

 

 

SNMP Variables Used for Setting Time

The following variables are provided in order to use SNMP to configure SNTP:

Variable

Description

SntpStatus

Read-write variable with two choices: enabled and disabled.

 

 

TimeZone

Read-write variable. Refer to the Time Zone Table for SNMP

 

fto determine the numerical identifier of the time zone you

 

wish to set.

 

 

PrimaryNTPServerFromDHCP

Read-only variable. Displays the primary NTP server

 

assigned by DHCP, if any.

AlternateNTPServerFromDHCP

Read-only variable. Displays the alternate NTP server

 

assigned by DHCP, if any.

 

 

NtpServersSearchOrder

Read-write variable with two choices: dhcpFirst and

 

staticFirst.

 

 

StaticPrimaryNTPServer

Read-write variable. IP address or name of static primary

 

NTP server.

94

Hypercom Corporation