Configuring the IN-tact 1101

Configuration Procedure

 

 

Materials Required

You will need the following in order to configure the IN-tact1101:

•A laptop or desktop PC with Internet browser (Microsoft Internet Explorer, version 5.0 or higher. Other browsers are not currently supported.)

•Two standard Ethernet cables (any length) - one to connect your PC to the hub; the other to connect the hub to the IN-tact1101.

•Access to a hub for connections to the PC and IN-tact1101 unit

•IN-tact1101 and power supply connected to standard AC power outlet.

Operating System Requirements

Windows 2000 Service Pack 3 or higher should be installed on the computer being used to configure the IN-tact.

Data Entry - Use of Special Characters

In general, do not use the "double-quote" special character (like the one surrounding the word) in data entry fields. It is not recognized as a valid character by the IN-tact1101. The exception to this is within dial strings. The double-quote character can be used with no problem when being defined as part of a dial string.

Internet Browser Recommendations

Some browser settings can cause extra system messages to appear and cause other issues. The following items are suggestions for browser setup while configuring the IN-tact1101:

•If you use a pop-up blocker, either temporarily disable it or enable it to allow pop-ups from the IN-tact1101. Otherwise, pop-up messages from the device may be blocked.

•Enable cookies (no prompt) to avoid numerous browser pop-ups about cookie acceptance

•Active scripting needs to be enabled. By default, active scripting is enabled in Internet Explorer. You can check or change the setting of this option in Internet Explorer by clicking Tools > Internet Options > Security tab > Custom Level. Scroll down the list to locate the Active Scripting option. Click to enable, if it is disabled.

•It is recommended to clear your browser’s cache before configuration or anytime you upgrade firmware for the device. This is particularly important after a firmware upgrade, as you may not see the most current Web Server pages unless you clear the browser’s cache.

Configuration Procedure

Use this procedure when you are ready to configure the IN-tact1101. If you have not already done so, please read the preceding section before beginning any configuration.

To configure the IN-tact1101:

1.Connect the IN-tact1101 to your PC or to a network hub. Use a standard Ethernet cable to connect the LAN port on the IN-tact1101 to a hub, or directly to an Ethernet port on the PC

10

Hypercom Corporation