Hypercom 1101 IN, Edit, Edit, Edit, Setup, Standard, Host Port, Save and Continue, Apply and Restart, Apply and Restart, Apply and Restart, Application Setup

Configuring the IN-tact 1101 Configuration Screens

transactions to a processor for troubleshooting purposes or other reasons. All IP addressing information remains intact. When you are ready to resume sending transactions to a processor you have disabled, click Enabled to resume normal operation.

4.There are three Connection Types - Standard, HTTP, and Merchant Link. Use the drop-down list to choose the appropriate type for this host processor, then click Edit at the end of the row.

NOTE: Click Save and Continue or Apply and Restart as appropriate. Keep in mind that your changes are not written to persistent memory until you click Apply and Restart. Any changes made on this screen are temporarily saved when you click Edit to access the next screen. You must still use Apply and Restart in order to write the changes to persistent memory.

Standard Host Settings Screen

(Used when configuring connections not requiring HTTP protocol)

On the navigation tree, click IN-tactSetup > Application Setup > Host Port. Select Standard connection type and click Edit.

The IN-tact1101 uses the addressing information entered here to route transactions to the appropriate destination. Both a primary and alternate IP address can be configured for each host processing function. Contact the host processor to obtain the correct IP and port address for routing if unknown.

36 Hypercom Corporation