Configuring the IN-tact 1101

Configuration Screens

 

 

Ethernet Port Settings Screen

On the navigation tree, click IN-tactSetup > System Setup > Ethernet Port. The Ethernet Port Settings screen appears:

Use this screen to set basic communication parameters for the Ethernet Port on the IN-tact1101. Only IP version 4 is supported. The MAC address can be changed in the rare event that MAC address filtering or other firewall issues are preventing the provided MAC address from working correctly. If not using DHCP, you are required to configure a valid IP address for the IN-tact1101 to be operational. You cannot permanently save the configuration until you do so.

Field/Button

Description

MAC Address

Unique address of this IN-tact1101.

 

 

Static IP Address

Change to match the IP addressing requirements for your network. By

 

default, DHCP is enabled and this field displays “192.168.1.20”.

 

 

Static Subnet mask

Change to match the local IP subnet of your network. The default is

 

255.255.255.0.

 

 

Static Gateway Address

Enter the gateway address used to route IP off the local subnet. The

 

default is 0.0.0.0.

Static DNS Server

Enter the IP address of the DNS server that should be used.

 

 

Enable DHCP

Enabled by default. Click to disable DHCP and use a static IP

 

address. If DHCP is enabled, both of the LEDs on the LAN connector

 

of the IN-tact1101 will flash in unison when the device is powered on

 

and is attempting to acquire an IP address.

NOTE: Click Save and Continue or Apply and Restart as appropriate. Keep in mind that your changes are not written to persistent memory until you click Apply and Restart. Any changes made on this screen are temporarily saved when you click Advanced to access the second screen. You must still use Apply and Restart in order to write the changes to persistent memory.

20

Hypercom Corporation