Configuring the IN-tact 1101

Configuration Screens

 

 

Terminal Port Settings Screen

On the navigation tree, click IN-tactSetup > Application Setup > Terminal Port. The Terminal Port Settings screen appears:

Use this screen to set the communication parameters for connection to your HLAN terminal network. Your settings here should match the configuration of your terminal network. You are required to configure at least one terminal for the IN-tact1101 to be operational. You cannot permanently save the configuration until you do so.

Field/Button

Description

HLAN Speed

Use the drop-down list to select either 19200bps (default) or 4800

 

bps. The speed selected should match speed set in the terminals.

Enabled

By default, all terminal addresses are disabled. Use this series of

 

checkboxes to enable any terminal address not being used. You can

 

also use this feature to temporarily disable a terminal that is not

 

responding to poll if it is affecting network performance.

Description

Type a brief text description of each terminal on the HLAN network,

 

such as “Register 1”, “Drive-thru”, etc. 32 characters are accepted.

 

 

CU Address

A listing of valid HLAN polling addresses. Make certain that the

 

Enabled checkbox is selected and there is a description for each

 

terminal address in use at this location. All unused addresses should

 

be disabled so they are not polled.

 

 

NOTE: Click Save and Continue or Apply and Restart as appropriate. Keep in mind that your

changes are not written to persistent memory until you click Apply and Restart.

34

Hypercom Corporation