5.
Note
If the power connector 2
and the other small
connector (not shown) are
fastened together with a
twist-tie, undo the twist-tie
and separate them.
Insert the SCSI hard disk into
the compartment 4. Insert the
power connector 2 into the
connector 3. Insert the
connector 5 into the connector
1. Push the SCSI hard disk in
until it stops.
Latches
If you need to remove the
SCSI hard disk, you must
release the latches. See
“Releasing the Latches” on
page 4-10.
6.
Install the blank bezel. Perform
the removal procedure in the
reverse order.
See “Removing the Blank Bezel” on page 4-8.
7.
If you have removed an adapter
card, reinstall it.
See “Installing an Adapter Card” on page 4-22.
Chapter 4. Installing and Removing IBM Options 4-15
Title: C74AMST CreationDate: 06/23/93 17:09:07