3745 FRU Exchange Procedure
Installation Procedure
1. Install the new terminator card.
2. Re-install the retainer.
3. Install the grid of the Basic board.
4. Close the rear door.
5. Switch CB1 ON.
6. Close the front door.
7. Press Power Off on the Control panel.
8. Referring to Chapter 3, “How to Run 3745
Diagnostics” on page 3-1, run the same diag-
nostic in ODG that you ran before you
exchanged the FRU.
9. Go to “Action to Take After a Diagnostic Run
or an FRU Exchange” on page 4-99.
Chapter 4. 3745 FRU Exchange 4-63