3745 FRU Exchange Procedure
Installation Procedure
1. Install the new connector with its internal
cable into the tailgate. Two screws must be
used.
2. Clamp the internal cable to the EAC card.
3. Replug the cable to the EAC card connector
(J1).
4. Replug the two cable ground wires to the
board.
5. Replug the EAC card.
6. Replace the three top card connectors.
7. Reconnect the external cable on the tailgate
connector.
8. Reinstall the cover of the Basic board.
9. Close the rear door.
10. Switch CB1 ON.
11. Close the front door.
12. Press Power On on the control panel.
13. Referring to Chapter 3, “How to Run 3745
Diagnostics” on page 3-1, run the same diag-
nostic in ODG that you ran before you
exchanged the FRU.
14. Go to “Action to Take After a Diagnostic Run
or an FRU Exchange” on page 4-99.
4-66 3745 Models 130 to 17A: MIP