Icom IC-R3 Memory Channels, General, Programming during selection, Memory channel contents

5 MEMORY CHANNELS

■General

The receiver has 400 memory channels in 8 banks (A–H) for storage of often-used frequencies.

◊Memory channel contents

The following information can be programmed into memory channels:

•Operating frequency (p. 8)

•Receive mode (p. 12)

•Tuning step (p. 8)

•Memory name (p. 17)

•Duplex direction (DUP or – DUP) with an offset frequency (p. 31)

•Tone squelch ON/OFF (p. 28)

•Tone squelch frequency (p. 28)

•Scan skip setting (p. 22)

■Programming during selection

qPush [↔] to select an operating band. w Set the desired frequency:

➥Set the frequency using [DIAL].

➥Set other data (e.g. offset frequency, duplex direction, tone squelch frequency, etc.), if required.

ePush [V/M] for 1 sec. to indicate memory channels.

•Do not hold [V/M] for more than 2 sec., otherwise the previously selected memory channel will be overwritten.

rRotate [DIAL] to select the desired channel.

•VFO (VF), as well as regular memory channels, can be pro- grammed in this way.

•Rotate [DIAL] while pushing [FUNC] to select a memory bank (A–H), programmed scan edge channel or VFO (VF).

tPush [V/M] for 1 sec. to program.

•Keep pushing for 2 sec. or more to automatically select the next memory channel, if desired.

[EXAMPLE]: Programming ch 40 of memory bank E during selection (and ch 41 selection).

FM	–DUP TSQL PSKIP		FM	M:A00			M:E40		FM	–DUP TSQL PSKIP
										E41
145.600.000			146.010.000		FUNC		. .		145.600.000
TS	15.0		TS	15.0	+	TS	.		TS	15.0
S1 3 5 7 9		V/M SKIP	S1 3 5 7 9			S1 3 5 7 9		V/M SKIP	S1 3 5 7 9
VOL			VOL		for bank	VOL			VOL
		for 1 sec.				for CH		for 2 sec.
	FM DUP TSQL		FM		selection	selection				FM DUP TSQL
	P							blank		P
								channel

14