Icom IC-R3 Programming a skip frequency, Frequency skip function ON/OFF, Scan Operation

6 SCAN OPERATION

■Frequency skip function

◊Programming a skip frequency

Unwanted frequencies can be skipped and programmed as skip channels when full scan, band scan or programmed scan is pausing.

qStart full scan, band scan or programmed scan. (p. 19) w While receiving an unwanted signal and scan pauses,

push [FUNC] + [(V/M) SKIP] for 2 sec. to program the re- ceived frequency as a skip frequency.

•The receiver emits 3 beeps and the scan resumes.

•Non-programmed memory channels (blank channels) are used for skip frequency programming in reverse sequence.

•To scan the skip frequency after programming, cancel the skip information (p. 22) or clear the memory channel (p. 16).

FM	PSKIP	FM	PSKIP
	2P		H49
370.475.000		370.475.000
TS	15.0	TS	15.0

S1		3	5	7 9	S1		3		5	7	9
RX					RX
VOL					VOL
	FM					FM
RX			P		RX			P
Indication while pausing					Indication while programming

◊Frequency skip function ON/OFF

The frequency skip function can be turned OFF. In this case, the frequencies will not be skipped even if skip information is programmed and “P SKIP” or “P ” does not appear.

qSelect VFO mode with [V/M].

wPush [FUNC] + [(V/M) SKIP] to toggle the frequency skip function ON or OFF.

• “PSKIP” or “P ” appears when the function is turned ON.

FM				FM				PSKIP
146.010.000				146.010.000
TS		15.0		TS		15.0
S1	3	5	7 9	S1	3			7	9
							5
VOL				VOL
FM				FM
						P
The frequency skip				The frequency skip
function is OFF.				function is ON.

24