19 QUICK REFERENCE
58
■SCAN
◊Full/band/programmed scan q Select VFO mode with [V/M].
w Make sure the squelch is set to the threshold point.
e Push [↔] for 2 sec. to start the scan.
•Rotate [DIAL] while pushing [↔] to select scan edge, if desired.
•To change the scanning direction, ro- tate [DIAL].
rPush [↔] again to stop the scan.
◊Memory (bank) scan
qSelect memory mode with [V/M]. w Make sure the squelch is set to
the threshold point.
e Push [↔] for 2 sec. to start the scan.
•Rotate [DIAL] while pushing [↔] to turn memory bank scan ON or OFF, if desired.
rPush [↔] again to stop the scan.
■SET MODE
qPush [FUNC] + [(MODE) SET] momentarily to enter set mode.
•Select
wRotate [DIAL] to select a display. e Push [↔] or rotate [DIAL] while pushing [FUNC] to set the condi-
tion.
r Push [(MODE) SET] to exit set mode.
■LOCK FUNCTION
Push [FUNC] + [(MODE) SET] for 2 sec. to toggle the lock function ON or OFF. (p. 9)
■CPU RESETTING
◊Partial resetting (p. 45)
While pushing [FUNC] and [V/M], turn power on to partially reset the receiver.
•Partial resetting does not clear the mem- ory channel contents.
◊Total resetting (p. 45)
While pushing [FUNC], [V/M] and [MODE], turn power on to reset the receiver.
Caution: Resetting the receiver initializes all memory contents.