Icom IC-R5 Scan edges programming, Example Programming 145.300 MHz into scan edges 03A

6 SCAN OPERATION

■Scan edges programming

Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 00A/00B to 24A/24B, in memory channels.

qPush [V/M•S.MW•~] to select VFO mode. wSet the desired frequency:

➥Select the desired band with [BAND•].

➥Set the desired frequency with [DIAL].

➥Set other data (e.g. offset frequency, duplex direction, tone

squelch, etc.), if desired.

ePush [V/M•S.MW•~] for 1 sec. to select select memory write condition.

•1 short and 1 long beeps sound.

•“ ” indicator and memory channel number blink.

rRotate [DIAL] to select the desired programmed scan edge channel from 00A to 24A.

tPush [V/M•S.MW•~] for 1 sec.

•3 beeps sound

•The other scan edge channel “B,” 00B to 24B, automatically se- lected when continuing to push [V/M•S.MW•~] after program- ming.

yTo program a frequency for the other pair of scan edges, 00B or 24B, repeat steps w and r.

•If the same frequency is programmed into a pair of scan edges, programmed scan will not function.

[DIAL]

[V/M•S.MW•~]

[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.

	Push	for 1 sec.	Rotate	Push	for 1 sec.
FM	P SKIP	FM			FM	P SKIP	FM	P SKIP

27