Icom IC-R5 Programmed scan operation, Programming scan edges, Selecting a scan edge channel a

QUICK REFERENCE GUIDE

■Programmed scan operation

25 pairs, 50 channels of memories are used for programmed scan operation, that specifying a scanning ranges. The pro- grammed scan scans between “xxA” and “xxB” (xx=00 to 24) frequencies. Therefore, before operating the programmed scan, different frequencies must be programmed into “A” and “B” channels.

DProgramming scan edges

A start frequency must be programmed into a “xxA,” and end frequency must be programmed into a “xxB” memory chan- nel.

1. Setting frequency

In VFO mode, set the desired receive frequency mode.

•When “ ” indicator is displayed, push [V/M•S.MW•~] to se- lect the VFO mode.

2. Selecting a scan edge channel “A”

Push [V/M•S.MW•~] for 1 sec., then rotate [DIAL] to select one of the de- sired scan edge channel “A.”

•“ ” indicator and scan edge channel number blink.

3. Writing a memory channel

Push [V/M•S.MW•~] for 1 sec. until 3 beeps sound.

•Scan edge channel “B” is automatically selected when continuing to push [V/M•S.MW•~] after programming.

•After programming is completed, return to VFO indication.

4. Selecting a scan edge channel “B”

Push [V/M•S.MW•~] for 1 sec., then rotate [DIAL] to select one of the de- sired scan edge channel “B.”

•“ ” indicator and scan edge channel number blink.

•When the scan edge channel “B” is already selected at step 3. (con- tinuing to push [V/M•S.MW•~] after programming), skip this step.

5. Writing a memory channel

Push [V/M•S.MW•~] for 1 sec. until 3 beeps sound.

•The next scan edge channel “A” is automatically selected when con- tinuing to push [V/M•S.MW•~] after programming.

•After programming is completed, return to VFO indication.

V