Icom IC-R5 instruction manual Memory channel programming

■Memory channel programming

qSet the desired frequency and other functions in VFO mode.

wPush [V/M•S.MW•~] for 1 sec. to enter select memory write

condition.

•1 short and 1 long beeps sound.

e Rotate [DIAL] to select the desired memory channel number. r Push [V/M•S.MW•~] for 1 sec. again to program the contents

into the selected channel.

•3 beeps sound.

■Scan skip setting

qPush [V/M•S.MW•~] to select memory mode.

wRotate [DIAL] to select the desired memory channel.

eWhile pushing [FUNC], push [V/M•S.MW•~] to set the skip setting (skip channel or skip frequency) ON and OFF.

■VFO scans

qPush [V/M•S.MW•~] to select VFO mode.

wPush [MODE•SCAN] for 1 sec.

•One of scan type “ALL,” “BAND” or “PROG xx” (xx= 0–24) appear.

eRotate [DIAL] to select the desired scan type.

Push [MODE•SCAN] momen- tarily to start scan.

•Rotate [DIAL] to change the scanning direction.

•During scan, push [V/M•S.MW•~] to start auto memory write scan.

rPush [MODE•SCAN] momen- tarily again to stop scan.

■Memory scans

qPush [V/M•S.MW•~] to select

memory mode.

•Push [BAND•] to select a bank, if desired.

wPush [MODE•SCAN] for 1 sec.

•One of scan type “ALL” or “BANK” appear, for bank scan. Rotate [DIAL] to select the desired scan type, in this case.

•When memory mode is selected at step q, memory scan starts.

ePush [MODE•SCAN] momen- tarily to start bank scan.

•Rotate [DIAL] to change the scanning direction.

rPush [MODE•SCAN] momen- tarily again to stop scan.