Icom IC-R5 instruction manual Memory Channels, General description

MEMORY CHANNELS 5

■General description

The receiver has 1050 memory channels including 50 scan edge memory channels (25 pairs) for storage of often-used frequencies. And a total of 18 memory banks, A to H, J, L, N, O to R, T, U and Y are available for usage by group, etc. Up to 100 channels can be assigned into a bank.

DMemory channel contents

The following information can be programmed into memory channels:

•Operating frequency (p. 9)

•Receive mode (p. 12)

•Duplex direction (DUP or –DUP) with an offset frequency (p. 14)

•Tone squelch or DTCS squelch ON/OFF (p. 35)

•Tone squelch frequency or DTCS code with polarity (pgs. 36, 37)

•Scan skip information* (p. 30).

■Memory channel programming

qPush [V/M•S.MW•~] to select VFO mode. wSet the desired frequency:

➥Select the desired band with [BAND•].

➥Set the desired frequency with [DIAL].

➥Set other data (e.g. offset frequency, duplex direction, tone

squelch, etc.), if desired.

ePush [V/M•S.MW•~] for 1 sec. to select select memory write condition.

•1 short and 1 long beep sound.

•“ ” indicator memory channel number blink.

rRotate [DIAL] to select the desired channel.

•Scan edge channel, 00A/B to 24A/B can also be selected.

•While pushing [FUNC], rotate [DIAL] to selects memory channel in 10 channels steps.

tPush [V/M•S.MW•~] for 1 sec.

•3 beeps sound

•Memory channel number automatically increases when contin- uing to push [V/M•S.MW•~] after programming.

4

5

[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel).

Push for 1 sec. Rotate Push for 1 sec.

FM DUP T SQL P SKIP FM FM DUP T SQL P SKIP FM DUP T SQL P SKIP

16