131

Adding or Replacing PCI/PCI-X Cards

Note: If you are adding or replacing a half-height PCI card, skip ahead to step 6.

5.If the full-height card that you want to install does not fit in the carrier, follow these steps:

a.Loosen the three screws on the guide bar with a Phillips screwdriver (if your carrier uses T8 Torx screws, you will need a Torx screw driver).

b.Adjust the carrier guide bar (also known as the alignment rail) up or down as necessary (see Figure 6-17).

Carrier guide bar

Figure 6-17Adjusting the Carrier Guide Bar

007-4857-002