Operating Your System
Powering On Manually or With L1 Console
If your system does not have a a local system console, you can manually power on and off the server by using the power button(s).
To power on your system or an individual IRU manually, follow these steps:
1.If the monitors and other peripherals are equipped with voltage select switches, verify that they are set for the appropriate AC voltage and plug them in. Note that they are normally plugged into power sources outside the rack system.
2.Turn the circuit breaker switchs of the PDU to the on position, see Figure
3.Press the power buttons (see Figure
insideTM
L1 controller display
Power button with LED
Figure 1-21 Location of the Power Button
To boot the system from the L1 interface you must have a console connected to the system via the console port. Use the following commands depending on system type:
1.For a system that contains one IRU, enter the following command at the L1 prompt to power on the server:
2.For a system with multiple IRUs, enter the following command at the L1 prompt:
41 |
