Intel SGI Altix 450 manual Cabling the System IRUs to a Power Source

Cabling the System IRUs to a Power Source

The console output should indicate that the processors and memory on both IRU modules have been discovered. If the secondary IRU module has not been discovered, use the reset L1 command to perform a reset of the system.

Note: Use the network L1 command to set the network mode. (See the SGI L1 and L2

Controller Software User’s Guide (007-3938-00x) for more information on L1 commands.)

Cabling the System IRUs to a Power Source

This section describes how to make the following connections to a power source:

•“Connecting an IRU Module to a Power Source (No Rack)” on page 31

•“Connecting System Modules to a Rack Power Source” on page 34

Connecting an IRU Module to a Power Source (No Rack)

If you are operating your system on a table top, connect the IRU(s) to an approved electric receptacle. See Figure 1-15 for the location of the IRU’s power connectors.

007-4857-002 31