Juniper Networks M10i manual Replacing Routing Engine Components

M10i Internet Router Hardware Guide

If the LEDs are not lit in the appropriate pattern after 60 seconds, repeat the power supply and cable installation procedures described in “Installing a DC Power Supply” on page 114 and the previous steps in this section.

14.On the external management device connected to the Routing Engine, monitor the startup process to verify that the system has booted properly.

Figure 44: Connecting Power Cables to a DC Power Supply

Replacing Routing Engine Components

For instructions on replacing Routing Engine components, see the following sections:

■Replacing the Routing Engine on page 121

■Removing and Inserting the PC Card on page 124

■Removing and Inserting the Internal Flash Drive on page 126

■Removing and Inserting SDRAM Modules on page 129

■Replacing Connectors to Routing Engine Interface Ports on page 130

120■ Replacing Routing Engine Components